| OSEPP UNO R3 Plus |
1 |
| 6 feet USB type A to mini-B |
1 |
| Tact push switch 6mm x 6mm - through hole |
2 |
| DIP switch 4 position - through hole |
1 |
| 1Kohm potentiometer (variable resistor) - long pins |
1 |
| 10Kohm potentiometer (variable resistor) - long pins |
1 |
| 330 ohm axial resistor, 1/2W, 5% |
20 |
| 1 kohm axial resistor, 1/2W, 5% |
5 |
| 10kohm axial resistor, 1/2W, 5% |
5 |
| LED through hole - Red, 8.7mm height, ~2V drop, ~10-20mA |
2 |
| LED through hole - Yellow, 8.7mm height, ~2V drop, ~10-20mA |
2 |
| LED through hole - Green, 8.7mm height, ~2V drop, ~10-20mA |
2 |
| LED through hole - White, 8.7mm height, ~2V drop, ~10-20mA |
2 |
| LED through hole - Blue, 8.7mm height, ~2V drop, ~10-20mA |
2 |
| Two digits 7-segment LED - RED |
2 |
| Buzzer, 5Vo-p |
1 |
| NPN transistor |
2 |
| Breadboard - 30 columns x 14 rows (include 2 VCC and 2 GND) |
1 |
| 6 inches male-to-male jumper wires (red) |
10 |
| 6 inches male-to-male jumper wires (black) |
10 |
| 6 inches male-to-male jumper wires (white) |
10 |
| 6 inches male-to-male jumper wires (grey) |
10 |
| 6 inches male-to-male jumper wires (blue) |
10 |
| 4x AA battery enclosure with DC power jack and ON/OFF switch, cable length 4" |
1 |
| 2cm x 2cm x 3mm thick double side tape |
2 |
| Information sheet - Arduino UNO diagram + basic electronic theory |
1 |
| Kit container |
1 |
